S.O.P for Fitting Tying option cover with (Thread and Velcro) on seat Assembly.

• Place the seat cover on clean and plain surface.
• Open the male and female Velcro of Joyride seat cover. (refer below image)

• Check the proper direction of your seat and place it over Joyride seat cover.
• Make sure the cover fits properly on every side of the seat. (As shown in the images below)
• Apply adequate force and tie the thread of seat cover with metal hook, which is located at the back side of seat assembly (As shown in the images below)

• Make sure that the applied force does not damage the thread.
• As shown in picture, remove wrinkles from upper side of the seat cover manually by hand pressing .

• After removing wrinkles start to connect both the sides of the Velcro.
• While connecting either sides of the Velcro, apply enough force in such a way that every lose fitting side fits tight on the seat removing the remaining wrinkles if any. Manually Hand press the seat cover to give it a finishing touch. (As shown in the images below)

• Check the below sample images how seat fitting appears after this exercise.

• Once the seat cover fitting is done, it is advisable to do stapling for thread & Velcro at the opposite sides of front portion and bottom portion.
• Make sure while fitting the cover the thread does not become loose otherwise the fitting will become loose.
• With stapling, there are less jerks experienced while putting brakes.
• Stapling is more reliable than thread, hence additional four corner point stapling is advisable.